Premium splash resistance tester manufacturer? GESTER is professionally engaged in manufacture and R&D of Textile Testing Equipment with 20+ years experience, including Fabrics tests, Yarn& Fibre tests, Color fastness tests, Flammability tests etc. Various in styles, GESTER instruments’s textile testing equipment can meet the needs of different customers.GESTER insists on the use of high-quality materials and advanced technology to manufacture textile testing instruments. Besides, we strictly monitor and control the quality and cost in each production process. All this guarantees the product to have high quality and favorable price.GESTER serves every customer with the standards of high efficiency, good quality, and rapid response. Find additional details at synthetic blood penetration test equipment.
Pneumatic Bursting Strength Testing Machine For determining the bursting strength of woven or knitted fabrics, non-woven, paper, leather and board by application of a pneumatic load under a rubber diaphragm of a specific area. Provide with a digital readout of pressure with peak value hold facility, renewable rubber diaphragms, and manual clamping device with acrylic bell, forward reverse and neutral drive system. Provide accurate elongation information of fabrics, up to 0.1mm.
The power must be turned off when going to work. Basic functions of utm wholesale universal tensile testing machine: tensile properties, tensile strength and deformation rate, tensile strength, tear resistance, heat sealing strength performance, roller peeling test, 90 degree peeling, rope breaking force, pants tear Force, 180 degree peeling, compression test, bending test, shear test, burst test, etc. to complete different tests, according to customer needs, can install different fixtures, wide specimen fixtures, etc.
The values stated in SI units are to be regarded as the standard, with the exception of mils when determining coating thickness.Test Procedure: The haze or original weight of test specimen is measured. The test specimen is then placed on the taber wear and abrasion tester. A 250, 500, or 1000-gram load is placed on top of the abrader wheel and allowed to spin for a specified number of revolutions. Different abrading wheels are specified. A haze measurement or final weight is taken. The load and wheel can be adjusted for softer and harder materials.
Reagent Preparation: Prepare corresponding reagents according to different test standards and keep them as standby. If sodium perborate is required in the test, the preheating temperature shall not exceed 60℃ when preparing the solution, and it shall be used within 30 minutes at most to prevent the loss of oxidant. Solution Warm-up: Put the specified volume of solution and a specified number of steel balls into the stainless steel cup, put the stainless steel cup into the launderometer for a few minutes, preheat to the specified temperature. Then put in the prepared sample for test. See more info on gesterinstruments.com.
