Ultrasonic tank level measurement online store by drurylandetheatre.com? For the monitoring of toxic, highly corrosive and dangerous liquids, HS-ULC-Pro Ultrasonic Non-contact Liquid Level Controller is an ideal choice. Sino-Inst offers a variety of Radar Level Transmitters for level measurement. If you have any questions, please contact our sales engineers. Advanced signal processing methods. Can overcome the influence of temperature drift. Stronger anti-interference; Brand new installation method. Adsorption type + adhesive type. Can improve the stability of the probe; Built-in temperature sensor. Monitor temperature changes for 24 hours. Temperature compensation is also possible; Adopt a new single probe mode. Installation is more convenient. Avoid repeated verification; A new handheld operator can be used to debug the instrument. The probe status can be detected to ensure reliable installation of the probe. It can support on-site upgrade of digital probe software. The historical data of the secondary meter can be read wirelessly.
The advantages of ultrasonic liquid level gauge are very outstanding. It is mainly reflected in the following aspects : Adopt non-contact measurement. It is not easily affected by the viscosity and density of the liquid. Of course, the ultrasonic liquid level gauge also has its own limitations and insurmountable defects. Specifically, it is mainly manifested in: Ultrasonic liquid level measurement is easily affected by temperature. In the actual measurement, the change of temperature will cause the change of sound speed. This will lead to errors in the measurement.
In the measurement, the ultrasonic pulse is emitted by the sensor (transducer), and the sound wave is reflected by the liquid surface and then received by the same sensor or ultrasonic receiver. Through piezoelectric crystal or magnetostrictive device into electrical signals. The distance between the sensor and the measured liquid surface is calculated by the time between the transmission and reception of sound waves. See even more details at Liquid Level Controller.
For spherical tanks equipped with a calibrator. The calibration sensor is installed at the center of the calibrator on the outer wall of the tank. If the calibrator is not installed, the calibration sensor should be installed at the height of the outer radius of the tank (equatorial zone). The calibration sensors for the vertical tank and the process tank are installed on the outer side of the tank body, at a height of 0.5m to 1m from the tank bottom. Note: After installing the calibration tube (calibrator) in the tank, the correct installation position should be marked with paint on the outside of the tank wall in time.
Ultrasonic Level Switch is not affected by factors such as medium density, dielectric constant, conductivity, reflection coefficient, pressure, temperature, precipitation, etc. It is suitable for various liquid levels in the pharmaceutical, petroleum, chemical, electric power, food and other industries Engineering control. Ultrasonic Level Switch is the ideal choice for the detection of toxic, highly corrosive, and dangerous liquid level. Sino-Inst offers a variety of Radar Level Transmitters for level measurement. If you have any questions, please contact our sales engineers. See more information on here.
